Core Drill Bit “DIAMATIP™”

Specifically designed to cut hardplate with either solid carbide or a carbide chip matrix.

Diamatip's specially designed tip is coated with diamond chips and works with a blue lubricant inserted in the core of the drill bit. As the Diamatip starts cutting, it creates heat that melts the special lubricant, flushing all surfaces of unwanted debris.

With the Diamatip, it's possible to achieve a 20-25 minute penetration through the carbide matrix used in many GSA containers – without having to use a “punch or drill” technique. With care, you should be able to penetrate 11/2" – 2" plates per cutter.

A small tube of lubricant is included with each bit.