The new ZIEH-FIX® electric pick from Wendt - quality made in Germany
Our battery operated electric pickgGun uses the percussion principle. The necessary vibration frequency and strength of the pick is delivered by an eccentric. Therefore easy picking of pin tumbler locks is possible.
Product: | Base Kit | Default set | Complete set |
---|---|---|---|
3600-K Case with foam inserts |
|||
Basic unit Elektro-Pick V3 |
|||
3598 Elektro-Pick tension tool set |
|||
9780 USB charger with cable |
|||
3498 V2 Torque & Tension Tool TNT-20 |
|||
3501-V2 Plug Spinner "Flipper" V2 |
|||
3620 Pick Needle Set "Novum" in leather case |
|||
355,38 € | 409,06 € | 532,82 € |
One of the main reasons for unsuccessful attempts of opening with picking tools is the lack of knowledge of how important the correct tension is. Tension is merely used to disarrange the cylinder plug in the cylinder housing and to so create a little ledge (step) between plug and housing.
During picking the pins or discs of the lock system should be fixed under respectively also above this ledge so that the shear line is free and the plug can be turned.
In order to get the pins and discs into the correct position with a picking tool they need to be movable despite the applied tension. An incorrect tension (too much) would block the pins or discs in the shear line.
In order to get the pins and discs into the correct position with a picking tool they need to be movable despite the applied tension. An incorrect tension (too much) would block the pins or discs in the shear line.
For unknown lock systems usually the straight needle is attached to the Electro-Pick at the intended spot. To avoid destruction of the fine screw thread of the tightening screw only hand-tight the screw.
Now apply tension to the plug with the tension tool and insert the Electro-Pick into the key way so that the picking needle is axial above respectively according to lock system below the pins or discs.The pins or discs should not be touched in this position; the pick needle needs to be minimally above or depending on lock system below the pins or discs.
The pick needle is inserted so far into the key way that all pins or discs can be moved simultaneously by the pick needle. The pick needle should not be inserted too far to the back so that it is not blocked by solid parts from the lock system or the lifting of the needle is restricted.
The pick needle should only swing in short intervals. This increases the chance of opening immensely. A permanent hitting of the pick needle against the pins or discs only increases the wear and tear of the needle and will not lead to the desired opening!
After some intervals the lock core should turn in the direction of the chosen tension, i.e. all pins or discs are out of the shear line, the shear line is free and the lock is open.